Learning
Start Here
A) Outline
B) Basics
C) Generator
D) Prime Mover
  1a) What's a Prime Mover?
  b) Combustion
  2a) What's an Engine?
  b) Gasoline Engine
  c) Diesel Engine
  d) Natural Gas Engine
  f) Engines: Pros & Cons
  g) Typical Installation
  h) Cogen Installation
  3a) What's a Turbine?
  4a) What's a Gas Turbine?
  b) GT - Uses
  c) GT _Pros & Cons
  d) GT Typical Installation
  e) GT Cogen Installation
  f) GT Combined Cycle
  g) Micro-turbines
  5a) What's a Steam Turbine?
  b) Design Considerations
  6a) What's a Boiler?
  b) Simple Power Boiler
  c) Cogen Boiler
  7a) What's a Water Turbine?
  b) Dams
  c) Rivers & Tides
  8a) What's a Wind Turbine?
  9) Recap: Prime
E) Fuel
F) Distribution
Finish Here

 

 
 
D9a) Recap: Prime Mover

Here are the key points from this section:

  • Internal Combustion Prime Mover burns fuel within the engine itself (like a diesel engine or gas turbine).
  • External Combustion Prime Mover burns the fuel in a separate chamber (like a boiler and steam engine).
  • Power is produced by the expansion of hot combustion gases against one of the working surfaces of the engine, such as the face of a piston, a turbine blade or a nozzle.
  • Non-Combustion prime movers convert existing mechanical energy directly into electricity.
  • An Engine is an internal combustion prime mover (so the fuel is burned inside the engine) that creates a backwards and forwards motion (reciprocating). It is cheap, low tech, and easily available.
  • A Turbine converts the kinetic energy of a moving fluid into mechanical power by the reaction of the fluid with a series of buckets, paddles, or blades arrayed about the circumference of a wheel or cylinder. They are expensive, high-tech machines that deliver a high power-to-weight ratio.
  • A Gas Turbine is basically two sets of fan blades attached to a single shaft. In between the two sets of blades, a fuel is burned. The expanding gases that result from the combustion push on the blades, causing them to spin.
  • A Steam Turbine is a collection of circular fan blades (just like a domestic fan) all attached to one rotor, inside a cylindrical casing. Steam is fed into one end, and as it expands, it pushes against the blades, causing them (and the rotor to which they are attached) to spin.
  • A Boiler is a piece of equipment that converts a liquid into a vapour – most commonly, water into steam.
  • A Water Turbine converts fast moving water into mechanical energy. Much like other turbines, it is basically a fan blade attached to a shaft. Water pushes on the blades, making the turbine spin.
  • A Wind Turbine converts the energy in moving air into usable energy. It is basically just a sophisticated version of a windmill. It’s a series of fan blades, arrayed around a shaft that turns a generator.

Let's tak a look at the Fuel that we use in our powerhouses.

  02-May-2024 Site Map Glossary Tools Terms & Conditions Back to Top